Filter
Top Products
OM-206 Page 16
ST-159 059 / S-0769
1 Amperage Adjustment Control
Use control to select weld amper-
age. Amperage may be adjusted
while welding.
2 Amperage Control Switch
Use switch to select way of control-
ling amperage adjustment.
For front panel control, place switch
in Panel position.
For remote control, place switch in
Remote 14 position (see Section
3-5).
See Example below.
3 Remote Foot Control
4 Remote Hand Dial
5 Fingertip Control
3
Set Switches Adjust Remote ControlSet Control
EXAMPLE Of Combination Remote Amperage Control
Control Setting
5
(80 A)
1
2
Unit
Minimum
4
4-3. Amperage Controls
1 Weld Process Switch
Use switch to select type of weld
output current. Use GTAW position
for Gas Tungsten Arc Welding. Use
SMAW position for Shielded Metal
Arc Welding.
Switch position determines the op-
eration of the Lift-Arc switch (see
Section 4-5).
1
4-4. Weld Process Switch