Filter
Top Products
OM-1330 Page 28
6-6. Aligning Drive Rolls and Wire Guide
Y Turn Off power.
View is from top of drive rolls
looking down with pressure
assembly open.
1 Drive Roll Securing Nut
2 Drive Roll
3 Wire Guide
4 Welding Wire
5 Drive Gear
Insert screwdriver, and turn screw
in or out until drive roll groove lines
up with wire guide.
Close pressure roll assembly.
Ref. 800 412-A
Correct Incorrect
4
3
2
1
5
Tools Needed:
6-7. Removing Knob From Front Panel
Y Turn Off power.
1 Front Panel
2 Knob
3 Slot
4 Control Shaft
Rotate knob to allow access to slot.
Insert tip of screwdriver into slot,
and while pushing on spring clip,
pull knob off control shaft.
To reinstall, push knob fully onto
control shaft.
803 863-A
3
2
1
4