Filter
Top Products
OM-229 038 Page 13
3-9. Installing Drive Rolls and Wire Guide
1 Securing Screw
2 Inlet Wire Guide
Loosen screw. Slide tip as close to
drive rolls as possible without
touching. Tighten screw.
3 Anti-Wear Guide
Install guide as shown.
4 Drive Roll
The drive roll consists of two differ-
ent sized grooves. The stamped
markings on the end surface of the
drive roll refers to the groove on the
opposite side of the drive roll. The
groove closest to the motor shaft is
the proper groove to thread.
Turn nut one click to secure drive
roll.
Tools Needed:
5/64 in
7/16 in
2
1
3
4
221-253-7