Miller Electric 15A Welder User Manual


 
OM-1213 Page 10
SECTION 4 INSTALLATION
4-1. Specifications
Wire Diameter
Range
Approximate
Wire Feed
Range
Cooling
Method
Maximum
Spool Size
Weld
Circuit
Rating
IP Rating
Overall
Dimensions
Weight
.025 Thru 1/16 in
(0.6 Thru 1.6 mm)
Aluminum Wire
.025 Thru .045 in
(0.6 Thru 1.1 mm)
Hard Or Cored Wire
70 To 875 ipm
(1.7 To 22.2
mpm)
Air Cooled
4 in (102 mm)
Diameter
100 Volts,
200 Amperes,
100% Duty
Cycle Using
Argon
Shielding Gas
IP 23
Length: 15-3/8 in
(390 mm)
Width: 2-1/2 in
(64 mm)
Height: 10-3/4 in
(273 mm)
2.9 lb
(1.3 kg) Gun
Only
15A Model:
9 lb (4.1 kg)
Gun With Cable
30A Model:
14 lb (6.4 kg)
Gun With Cable
Use weld control or welding power source Owner’s Manual during gun installation.
If contact tip, liner, and drive roll groove are not correct for wire size and type, see
Section 6 to change parts as needed. See Parts List for other available contact
tips.
NOTE
4-2. Removing Top Cover
150 882-G
1 Top Cover Triangular Boss
Push up on triangular boss to open
door. Door hinges on handle.
To open door fully, push up on door
until it clicks into position.
. If door is pushed too far it will
separate from handle. If this
happens the door can be rein-
stalled.
Push door back into original posi-
tion to close.
1