Filter
Top Products
Page 12
SECTION 7 − INSTALLING OPTIONAL MAGNIFYING LENS
. To prevent lens fogging, install flat side of magnifying lens toward auto-darkening lens.
XLi –
Magnifying lenses can be adapted to the XLi helmet as follows:
1 Pull outside lens cover/holder free from helmet.
2 Position magnifying lens over auto-darkening lens between the four center-
ing tabs.
3 Reinstall outside lens cover/holder over top of magnifying lens.
4 Reverse procedure to remove magnifying lens.
Xlix –
Installation:
1 Locate magnifying lens holding tabs on lens assembly on inside of helmet.
2 Place left side of the magnifying lens under the left side holding tabs.
3 Gently push down on right side of magnifying lens. Both sides of lens should
snap in place.
Removal:
1 Remove helmet external shade control knob by prying off with a screwdriver
or pulling off with a pliers.
2 Remove the shade control retaining nut and allow the control to fall free in-
side the helmet.
3 Remove front lens cover frame by sliding it up toward top of helmet.
4 Place one hand inside helmet and apply slight pressure to the bottom of the
lens assembly. With other hand, push down on the two bottom retaining tabs
on the front of the helmet. Catch lens assembly as it is released from helmet.
5 Slide magnifying lens up and away from the lens holding tabs.
Elite −
1 Remove lens holding frame (with auto-darkening lens) from helmet shell.
2 Remove auto-darkening lens from lens holder.
3 Position lens holder with magnifying lens holding tabs facing toward you.
From the bottom up, slide magnifying lens into position. (Slide magnifying
lens up or down slightly as desired.)
4 Reinstall the auto-darkening lens in the lens holder.
5 Reverse procedure to remove magnifying lens.