Filter
Top Products
6 7
Inserting Battery Pack into Tool
The battery pack may feel warm after the
charging cycle. If it is warm, maximize the
output of the battery by allowing it to cool for a
few minutes before inserting it into the tool.
Battery pack can be inserted into the tool
in two ways.
1. For working in restricted spaces, insert
the battery pack from the front by sliding
battery pack into the body of the tool.
Insert the battery pack until the battery
latches lock.
2. For optimum weight distribution and
balance, insert the battery pack from the
back by sliding the battery pack into the
body of the tool. Insert the battery pack
until the battery latches lock.
3. To remove the battery pack, press in
both battery latches and slide the battery
pack off of the tool.
WARNING
ASSEMBLY
Always lock trigger or remove
battery pack before changing or re-
moving accessories. Only use acces-
sories specifi cally recommended for
this tool. Others may be hazardous.
WARNING
To reduce the risk of injury, always
use a side handle when using this
tool. Always brace or hold securely.
Installing the Side Handle
To install the side handle:
1. Loosen the side handle grip until the ring
is large enough to slide over the torque
selector collar.
2. Rotate the handle to 90° left or 90° right
of the trigger handle.
3. Push the ring tightly against the side
handle ribs on the tool. The indent in the
side handle must fi t over the appropriate
rib.
4. Tighten the side handle grip securely.
5. To remove the side handle, loosen the
side handle grip until the ring is large
enough to slide off the tool.
WARNING
Recharge only with the charger
specifi ed for the battery pack. For
specifi c charging instructions, read
the operator’s manual supplied with
your charger and battery pack.
WARNING
Always remove battery pack before
changing or removing accessories.
Only use accessories specifically
recommended for this tool. Others
may be hazardous.
Bit holder
Clip-Lok
TM
System
The Clip-Lok system consists of three
pieces; the belt clip, the tool holder, and the
bit holder.
The system is shipped assembled for right-
handed use. To change the assembly for
left-handed use:
1. Remove battery pack.
2. Remove screws holding the tool holder
and the bit holder.
3. Lift the holders at the narrow end and
pull the front tangs out of their slots.
4. Replace the pieces onto the desired
side by sliding the tangs into the slots.
Tighten the screws securely.
Fig. 2
Attaching the Belt Clip
The belt clip can be mounted to tool belts,
bags, buckets, etc. To mount the belt clip:
1. Pull up the clamp release. The clamp
will pop out.
2. Slide the clamp over the tool belt, bag,
bucket, etc.
3. Press in the clamp to tighten.
Using the Clip-Lok Tool Holder
1. To attach the tool to the belt clip, slide
the tool holder over the stud on the belt
clip until it is held in place by the protrud-
ing pin.
2. To release the tool from the belt clip,
grasp the tool handle, push down on
the tool release lever with your thumb,
and pull up on the tool.
Using the Clip-Lok Bit Holder
The bit holder holds two standard 1/4" hex
shank bits up to two inches long.
1. Insert the bit by pressing it into the
clip.
2. Remove the bit by lifting the tip of the
bit and pulling it out of the clip.
Belt clip
Tool release lever
Stud
Pin
Clamp
Clamp
release
Tool holder
Front tangs
90° left
Side
handle
rib
Indent
Fig. 1