Milwaukee 5368-22 Power Hammer User Manual


 
4 5
FUNCTIONAL DESCRIPTION
1. Depth gauge
2. Side handle
3. Nameplate
4. Trigger
5. Handle
6. Forward/Reverse switch
(on other side of tool)
7. Hammer/Drill shift knob
8. Chuck collar
9. Dust shield
10. Bit (not included)
2
3
4
5
6
1
8
9
10
7
Double Insulated
Symbology
Volts Alternating Current
No Load Revolutions per
Minute (RPM)
Amps
Canadian Standards
Association
Underwriters Laboratories, Inc.
BPM
Blows per Minute
Mexican Approvals Marking
The grounding prong in the plug is connected
through the green wire inside the cord to
the grounding system in the tool. The green
wire in the cord must be the only wire con-
nected to the tool's grounding system and
must never be attached to an electrically
“live” terminal.
Your tool must be plugged into an appropri-
ate outlet, properly installed and grounded in
accordance with all codes and ordinances.
The plug and outlet should look like those
in Figure A.
Double Insulated Tools:
Tools with Two Prong Plugs
Tools marked “Double Insulated” do not
require grounding. They have a special
double insulation system which satisfies
OSHA requirements and complies with
the applicable standards of Underwriters
Laboratories, Inc., the Canadian Standard
Association and the National Electrical
Code. Double Insulated tools may be used
in either of the 120 volt outlets shown in
Figures B and C.
Grounded Tools:
Tools with Three Prong Plugs
Tools marked “Grounding Required” have a
three wire cord and three prong grounding
plug. The plug must be connected to a prop-
erly grounded outlet (See Figure A). If the
tool should electrically malfunction or break
down, grounding provides a low resistance
path to carry electricity away from the user,
reducing the risk of electric shock.
Fig. B
Fig. C
Fig. A
Improperly connecting the grounding
wire can result in the risk of electric
shock. Check with a quali ed electri-
cian if you are in doubt as to whether
the outlet is properly grounded. Do
not modify the plug provided with
the tool. Never remove the grounding
prong from the plug. Do not use the
tool if the cord or plug is damaged.
If damaged, have it repaired by a
MILWAUKEE service facility before
use. If the plug will not t the outlet,
have a proper outlet installed by a
quali ed electrician.
GROUNDING
WARNING
Speci cations
Catalog
Number
5366-21
5368-21
5368-22
Amps
7.2
7.2
7.2
No Load
RPM
0 - 1100
0 - 1100
0 - 1100
No Load
Blows/
Minute
0 - 5000
0 - 5000
0 - 5000
Carbide-Tipped
Percussion
Bits
5/32" - 7/8"
5/32" - 7/8"
5/32" - 7/8"
Twist
Drill Bits
1/2"
1/2"
1/2"
Rotary Hammer
(concrete)
Thin Wall
Percussion
Core Bits
2"
2"
2"
Volts
AC
120
120
120
Drill Only
(steel or wood)