Filter
Top Products
page 6
OPERATION
Starting and Stopping the Motor
1. To start the tool, pull the trigger.
2. To stop the tool, release the trigger.
1. To lock the trigger on, hold the lock-on button in while pulling the trigger.
Release the trigger.
2. To unlock the trigger, pull the trigger and release. The lock-on button
will pop out.
Locking the Trigger (Fig. 4)
Select Models
The lock button holds the trigger in the ON position for continuous use.
Sanding Disc and Grinding Wheel Selection
Use sanding discs and grinding wheels that are:
correct size as written on tool's nameplate
correct wheel type and grit for the job
rated at or above the RPM listed in the WARNING section on
the tool's nameplate
Use backing pads, adapters, and other accessories that are:
correct size for tool and for sanding disc or grinding wheel
rated at or above the RPM listed in the WARNING section on
the tool's nameplate
the proper accessory for the job
Sanding Disc and Grinding Wheel Material
Sanding discs and grinding wheels are made of various materials and are
designed for different jobs. Be sure that you choose the proper sanding disc
or grinding wheel for the job you plan to do.
Fig. 4
Lock-on button
1. Unplug tool.
2. Press and hold the handle release button in and rotate the rear handle
to one of the nine handle positions. The adjustable handle feature
has detents which allow the handle to snap into position. Make sure
the handle snaps firmly into position and does not rotate.
Position the guard in the location which offers best control and guard
protection. For operating zones that provide maximum protection for the
operator, see Fig. 9.
Adjusting the Rear Handle Position (Fig. 5)
Select Models
This tool is equipped with an adjustable rear handle. This feature
allows the user to adjust the angle of the handle to nine positions for opti-
mum operating positions.
Handle
release button
(on bottom)
Fig. 5
WARNING!
To reduce the risk of injury, wear safety goggles or glasses
with side shields.
WARNING!
To reduce the risk of injury or damage to the tool, do not use
the spindle lock button to stop the spindle while the tool is
in use or is coasting after shut-off.
WARNING!
To reduce the risk of injury, do not operate tool with handle
release button pressed in or with handle not locked into
position. If the handle does not lock securely into position,
do not operate tool. Return the tool to a MILWAUKEE service
facility for repair immediately.
WARNING!
To reduce the risk of personal injury and damage to the tool,
use ONLY accessories rated at or above the RPM listed on the
WARNING section of the tool's nameplate.
WARNING!
To reduce the risk of injury, always unplug tool before
attaching or removing accessories or making adjustments.
Use only specifically recommended accessories. Others
may be hazardous.