Filter
Top Products
page 8
WARRANTY
Every MILWAUKEE product is warranted to be free from defects in
material and workmanship. MILWAUKEE will repair or replace any product
which examination proves to be defective in material or workmanship.
Limitations: This warranty does not cover: 1) repairs made or at-
tempted by other than MILWAUKEE or MILWAUKEE Authorized Service
Station personnel; 2) normal wear and tear; 3) abuse; 4) misuse;
5) improper maintenance; 6) continued use after partial failure; 7) tools
that have been modified; or product used with an improper accessory.
Battery Packs are warranted for one (1) year from the date of purchase.
Should a problem develop, return the complete product to any
MILWAUKEE Factory Service Center or MILWAUKEE Authorized Ser-
vice Station, freight prepaid and insured. If inspection shows the prob-
lem is caused by a defect in material or workmanship, all repairs or a
replacement will be made at no charge and the product will be returned,
transportation prepaid. No other warranty, written or verbal, is authorized.
THE REPAIR AND REPLACEMENT REMEDIES DESCRIBED HEREIN ARE
EXCLUSIVE. IN NO EVENT SHALL MILWAUKEE BE LIABLE FOR ANY
INCIDENTAL, SPECIAL, OR CONSEQUENTIAL DAMAGES, INCLUDING
LOSS OF PROFITS.
THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESSED OR
IMPLIED WHETHER FOR MERCHANTABILITY OR FITNESS FOR PARTICULAR
USE OR PURPOSE.
This warranty gives you specific legal rights. You may also have
other rights that vary from state to state. In those states that do not
allow the exclusion of implied warranties or limitations of inciden-
tal or consequential damages, the above limitations or exclusions
may not apply to you.
For a complete listing of accessories refer to your MILWAUKEE Electric
Tool catalog. To obtain a catalog, contact your local distributor or a
service center listed on the back cover of this operators manual.
Quik-Lok
®
Cord Sets
8' Quik-Lok
®
Cord
Cat. No. 48-76-4008
25' Quik-Lok
®
Cord
Cat. No. 48-76-4025
Offset Blade Adapter
Select Models (Fig. 7)
Cat. No. 48-03-2010
An offset blade adapter is available to make flush cuts possible. To
attach, remove blade clamping screw and blade clamp. Place adapter
over spindle, lining up hole in adapter casting with threaded hole in
spindle. Replace screw, attaching adapter to spindle. Blade can then
be secured in adapter blade clamp in the same manner it was secured in
the spindle clamp.
ACCESSORIES
Select Models:
Blade Clamp
Cat. No. 42-68-0647
Blade Clamp Screw
Cat. No. 06-83-2960
787 Blades:
Blade Clamp
Cat. No. 42-68-0677
Blade Clamp Screw
Cat. No. 06-83-2960
WARNING!
To reduce the risk of injury, always unplug the
tool before attaching or removing accessories.
Use only specifically recommended accesso-
ries. Others may be hazardous.
Fig. 7