Mitsubishi Electronics HL650U Planer User Manual


 
EN-15
Initial setting
To load information on the projector such as model name and lamp operating time, set the projector data in
advance. Click the SETUP button on the ProjectorView main screen. The Projector Setup screen appears. Enter
data according to the description of each setting item.
(Note)
You can’t change the Projector model, Serial number, Operating hours, and Lamp hours. They are loaded from the
projector and displayed when the LAN controlled mode of Telnet setting is set to ON.
The entry fi eld of each setting item contains a blank character by default. When setting these items, delete the blank
characters.
Each setting item is described as follows:
ProjectorView (continued)
Projector name* Name to identify the projector
Projector model Model name of the projector
Projector location* Location of the projector
Serial number Serial number of the projector
SMTP IP address* IP address of the SMTP server used for e-mail transmission
(
Example: 192.168.0.1
)
E-mail address*
e-mail address to receive alert notifi cation e-mail
(
Example: administrator@XXX.XXX.XXX
) (up to 64 characters)
E-mail host* User-defi ned string displayed at the Internet header of e-mail message
(
Example: user
)
E-mail from* Sender of alert notifi cation e-mail
(
Example:
PJView@
XXX
.XXX.XXX
)
Operating hours Cumulative projector operating time
Lamp hours Cumulative lamp operating time calculated based on that LAMP MODE is LOW.
Installation date* Date when the projector was installed
Last lamp replacement date*
Date when the lamp was last replaced
Last maintenance date* Date when the projector was last maintenanced
Virtual remote enabled Display or hide the virtual remote controller (Check the box to display.)
* ) For data entry, use single-byte alphanumeric characters and symbols
(+ - / = @ * _ ! ? . , ; : # $ % & ( ) | < > [ ] { } " ')
.
(Note)
When the “Standard” lamp mode is selected, the indicated lamp operating time may exceed the indicated
operating time.