Filter
Top Products
about 6 hrs
1 hr
1 hr
increase 1
increase 1
At night, before going to bed you
can press down the SLEEP button
on the controller and the air-
conditioner will run by the
comfortable sleeping mode to
make you sleep more comfortable.
One hour after sleeping operation start, the temp. is 1 higher than the setting one. After another
hour the temp. rises 1 and then run continuously for another 6hrs' and then close. The actual temp.
is higher than the setting one which is to prevent from being too cool to your sleep.
In cooling, dehumidifying mode
One hour after start up, the temp. decrease 2 lower than the setting one. After another hour
decrease by more 2 .
The temperature will automatically rise by 1 after another 3hrs' operation, and then automatically
close after 3hrs' continuous operation. The actral temperature is lower than the setting one which
is to prevent from being too hot to your sleep.
In heating mode
SETTING T
SLEEP RUN BEGINS SLEEP RUN STOPS
1 hr
1 hr
3 hrs
about 3 hrs
decrease 2
decreases 2
increase1
SHUT DOWN
SLEEP RUN STOPS
Heat mode
SLEEP RUN BEGINS
SETTING T
SHUT DOWN
Cooling mode
Comfortable Sleep
Note:
In AUTO mode, unit will run in SLEEP function according to the operation mode.
After setting SLEEP function, it is forbidden to calibrate clock.
If the set sleep-time does not reach 8 hours, the unit will stop operation automatically after set
time is complete.
Set "TIMER-OFF" function first, then set SLEEP, and the sleep-set is performance; set TIMER-
ON function first, the sleep function can only be set before TIMER-ON; if set theSLEEP function
first, the TIMER function can not be set.
15
SWING
SET
LOCK
RESET
HEALTH
MODE SLEEP
CLOCK
TIMER
ON
OFF
*
MODE
FAN
HEALTH
TEMP
CLOCK SET
TIMER SLEEP
RESET
FILTER RESET
ON/OFF
AM
SET
OFF
AM
C
C
C
C
C
C
C
C
C
C
Note: Before using this function,
must adjust the clock, or the sleep
function will be disordered.
After setting sleep function, not allowed to adjust the clock. Can't use the remote controller
operate the AC. If so, please cancel the sleep function first.
After setting sleep function, can't set the timing function.
Operating Instructions
SWING
Sleep Function
FAN
TEMP
FRESH
LIGHT