Filter
Top Products
1.This unit no the above function and display
2.The outdoor unit no oxygen-bar function ot no functions fo non-negative ion unit.
3.When using remote controller, first point it to the receiving window of wire controller, and then operate
remote controller.A ìtickî tone will be uttered to indicate a right acceptance.
4.All the buttons except the sleeping button is no effective after wire controller received lock signal from
remote controller.
6
Used to turn on/off unit
Note: Wired remote
controller his key have compl
cooling running function.
16.Fan speed display
19.Auto Swing display
26.Fresh air state display
15.Timer ON/OFF display
18.Clock display
23.Health state display
Auto
Low Fan Med Fan High Fan Auto
20.Humidifying state display
When the wire
controller appears
abnormal condition,
use a sharp-pointed
article to press this
button to make the
wire controller
resume normal
6.Time Adjusting button
11.Sleep button
7.Reset button
29.Lock state display
13.Setting button
Used to confirm
the time of timer
and clock
2.Operation mode button
4.Clock button
Used to calibrate the time
of timer and clock
24.Electric heating display
Used to set working mode:
Auto, Cooling,
Dehumidifying,
Heating, Fan
10.Fan speed button
Used to set fan speed: Low
Fan, Med Fan, High Fan, Auto
9.Temperature Setting button
8.Swing button
Used to set Auto Swing or
Fixed air sending direction
22.Working mode display
Working mode
Auto operation
Cooling operation
Dehumidifying
operation
Heating operation
Fan operation
Remote controller
5.Timer button
Used to set the
mode of timer
SWING
FRESH
SET
LOCK
RESET
LIGHT
HEALTH
FAN
TEMP
MODE SLEEP
CLOCK
TIMER
ON
OFF
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
29
28
27
25
24
26
20
21
22
23
30
31
Make sure that the remote controller is used within 7 meters from receiver window of the wire
controller and there are no obstructions in between.
The remote controller or wire controller should be handled with care.
When operating the remote controller in an area where electronically controlled lights are installed
or wireless handsets are used, move closer to the indoor unit as the function of the remote controller
might be affected by signals from this equipment.
Used to set temperature,
temperature range: 16 C~30 C
Remote LCD display contents and key name and each key function introduction
3.Health
Used to control the
generating oxygen function
and negative ion-function
1.ON/OFF button
12.Fresh air
Used to set fresh air function
14.Lock button
Used to lock the operating
key and LCD contents
17.Battery energy display
21.Sleep mode display
Display when the health
running
25.Comfort running display
23.Temperature display
Used to display the setting
temperature and room temp.
27.Signal launch display
31.Signal lauch head
30.Light button
Used to realize control board
VFD light stable,light weaker,
light shut off etc.
8 12 17 19 20 24 25 26 30
Remote controller
(Operation of remote controller)
3 23
Note:
SET
ROOM
MODE
FAN
TEMP
CLOCK SET
TIMER SLEEP
RESET
FILTER RESET
HEALTH
SWING
C
ON
OFF
*
AUTO
ON/OFF
D