Filter
Top Products
PAGE 20 — STOW CUTTER 1 SAW — OPERATION & PARTS MANUAL — REV. #6 (06/06/08)
4. Place the
Choke Lever
(Figure 14) in the "
CLOSED
"
position.
STOW CUTTER 1 SAW — INITIAL START-UP
DO NOT attempt to operate the saw until
the Safety, General Information and
Inspection sections of this manual have
been read and thoroughly understood.
Depending on engine manufacturer,
operating steps may vary. See engine
manufactures operating manual.
Figure 12. Engine Fuel Valve Lever
Figure 13. Engine ON/OFF Switch
CAUTIONCAUTION
CAUTIONCAUTION
CAUTION
CAUTIONCAUTION
CAUTIONCAUTION
CAUTION
1. Ensure the diamond blade has been mounted correctly and
that it is raised above the surface you are about to saw.
2. Place the
fuel valve lever
(Figure 12) to the "ON" position.
3. Place the
Engine ON/OFF switch
(Figure 13) in the "ON"
position.
The CLOSED position of the
choke lever enriches the fuel
mixture for starting a COLD engine.
The OPEN position provides the
correct fuel mixture for normal
operation after starting, and for
restarting a warm engine.
The engine speed has
been set at the factory.
Changing the governor
speed could damage the
blade and/or the saw.
Figure 14. Choke Lever
NOTE
CAUTIONCAUTION
CAUTIONCAUTION
CAUTION
NEVER operate the saw in
a confined area or
enclosed area structure
that does not provide ample
free flow of air
.
ALWAYS wear approved eye and hearing
protection before operating the saw.
NEVER place hands or feet inside the belt
guard or blade guard while the engine is
running. ALWAYS shut the engine down
before performing any kind of maintenance
service on the saw.
INITIAL START-UP