Filter
Top Products
MQ-MIKASA MRH800GS ROLLER — OPERATION AND PARTS MANUAL — REV. #5 (05/27/08) — PAGE 23
MRH800GS — INSPECTION
Figure 11. Checking Scrapers
Checking The Vibrator Oil Level
1. Check vibrator casing for any oil leakage.
2. If any leakage is noticed, remove the level plug on the side
of the plate (Figure 9).
3. Check the oil level.
Figure 9. Checking Vibrator Oil Level
Figure 10. Checking Water Tank
Checking Scrapers
1. Check scrapers and make sure that they are not clogged
with mud, bent or damaged (Figure 11).
2. Adjust clearance between drums and scrapers as
necessary.
Figure 12. Positioning the Handle Bar
Vibrator Oil
Level Plug
Scrapers
Handle Bar
Release Pin
Be careful not to confuse the water tank with the
oil tank.
CAUTION :
Checking Bolts, Nuts and Screws
1. Check bolts, nuts, and screws on various parts of the
machine, including the engine, for proper tightness.
Positioning the Handle Bar
1. Release the handle bar release pin (Figure 12) and position
the handle bar to the lowered position before starting
operation.
2. When machine is not in use, release the handle bar release
pin and position the handle bar to the upright position.
Checking Levers and Horn
1. Check travel, vibration, and throttle levers to make sure
they are functioning properly (Figure 4).
2. With travel lever placed in reverse, push the deadman
device and verify that the travel lever returns to neutral
position. The travel lever stays in neutral position once the
deadman device is released.
3. Press the horn and verify that it functions properly.
DANGERDANGER
DANGERDANGER
DANGER
Motor fuels are highly
flammable and can be
dangerous if mishandled. DO
NOT smoke while refueling.
DO NOT attempt to refuel the pump if the
engine is
hot!
or
running
.
Checking Water Tank
1. Check the water tank to see if filled. Add water if necessary.
The water tank has a capacity of approximately 10 gallons
(40 liters) (Figure 10).
Fuel Check
1. Remove the fuel cap located on top of the engine fuel tank.
2. Visually inspect to see if the fuel level is low. If fuel is low,
replenish with unleaded gasoline using a strainer for
filtration. DO NOT top-off fuel. Wipe up any spilled fuel
immediately!