Filter
Top Products
PAGE 22 — MP1 — OPERATION AND PARTS MANUAL — REV. #3 (03/29/10)
CONNECTING THE POWER (FIGURE 10)
1. Place the power ON/OFF switch (Figure 10) in the OFF
position (down).
Figure 10. Power ON/OFF Switch (OFF)
2. Connect an extension cord (Figure 13) of adequate current
carrying capacity to the power plug on the electric motor.
3. MAKE CERTAIN that the correct size extension cord is used.
Undersize wires will burn out motors. Use Table 4 to determine
the correct extension cord size.
4. This unit is shipped from the factory with the
voltage selector
switch
(Figure 12) in the 115 VAC position. To change the
position of the switch from 115 VAC to 230 VAC, remove the
locking bolt and place the switch in the 230 VAC position. Re-
install the locking bolt to prevent accidently flipping the switch.
Figure 12. Voltage Selector Switch
CAUTIONCAUTION
CAUTIONCAUTION
CAUTION
NEVER grab or touch a live power cord
(Figure 11) with wet hands , the possibility
exists of electrical shock, electrocution, and
even
death!
NEVER use
a damaged
or
worn
extension cable when
connecting to a power source. Defective cables may cause
damage to the saw's electric motor or electrical shock.
PRE-SETUP (ELECTRIC)
Figure 13. Extension Cord Connection
seziSdroCnoisnetxE.4ELBAT
ROTOM
EGATLOV
CAV
'05
GNOL
'57
GNOL
'001
GNOL
PH5.1 511
01.ON .ON
01
.ON
8
PH5.1
032 1.ON
4
.ON
41
.ON
41
PH0.2 511
1.ON
0
.ON
8
6.ON
PH0.2
032 21.ON .ON
21
21.ON
Figure 11. Voltage Selector Switch