Filter
Top Products
3
Loading VISROPE
1.Setting VISROPE
2. Switching magazine inner lid
Lift the inner lid while holding the inner lid stopper on the magazine cover. Insert the inner lid until it snaps in the
orientation corresponding to the screw length.
3. VISROPE types and stopper block adjustment
Two types are available in the VISROPE for VL71-FLR, 30mm type and 22mm type. Depending on the type, the
position of the guide differs and the stopper block needs to be adjusted to fit for the screws used.
* The first VISROPE has an extended plastic strip as shown below, which is needed to drive the first screw.
Please confirm the presence of this extension when loading.
* The stopper block fixing cap screw, when loosened too much, can cause its head to protrude. Pay due attention
to it.
Open the magazine cover while pulling the
magazine lever.
Set the VISROPE to the magazine as shown
below. (Remove the rubber band from the
VISROPE.)