Filter
Top Products
6
5. Removal of VISROPE
To remove the VISROPE, pull out the VISROPE while the guide cover and the grip finger are open.
* Push the main body 5mm or so to facilitate withdrawal of the VISROPE.
6. Bit replacement
To remove the bit, first pick up the bit as much as possible while pulling the sleeve. Then, while pulling back
(pressing down) the top end, pull out the whole bit.
To mount the bit, insert the bit while pulling back (pressing down) the top end. Then, while pulling the sleeve,
insert the bit fully to its position and fix it by returning the sleeve. After this, make sure that the bit is fixed
completely at its position by moving it up and down.
* The bit is consumable. Worn-out bit may cause poor tightening or damage the screw head. Replace the bit
with a new one before it is worn out.