Filter
Top Products
4 5
• lead from lead-based paint
• crystalline silica from bricks and cement
and other masonry products, and
• arsenic and chromium from chemically-
treated lumber.
Your risk from these exposures varies,
depending on how often you do this
type of work. To reduce your exposure
to these chemicals: work in a well ven-
tilated area, and work with approved
safety equipment, such as those dust
masks that are specially designed to
fi lter out microscopic particles.
6. Keep hands away from all cutting
edges and moving parts.
Direct Current
Symbology
No Load Revolutions
per Minute (RPM)
Underwriters
Laboratories, Inc.,
United States and
Canada
1
2
4
5
6
FUNCTIONAL DESCRIPTION
1. Keyless chuck
2. Torque selector collar
3. Speed selector
4. Tool holder
5. Trigger
6. Control switch
7. LED
3
Specifi cations
Cat. No.
2601-20
Volts
DC
18 *
No Load
RPM
Low 0 - 350
High 0 - 1 400
Steel
1/2"
1/2"
Flat Bit
1-1/8"
1-1/8"
Auger Bit
1"
N/A
Hole Saw
2-1/8"
2-1/8"
Screws (dia.)
1/4"
1/4"
Capacities
ASSEMBLY
WARNING
Recharge only with the charger
specifi ed for the battery. For spe-
cifi c charging instructions, read the
operator’s manual supplied with
your charger and battery. This tool is
not compatible with V™-technology
or NiCd systems.
Inserting/Removing Battery Pack
Insert the battery pack from the front by
sliding battery pack into the body of the
tool. Insert the battery pack until the battery
latches lock. To remove the battery pack,
press in both battery latches and slide the
battery pack off of the tool.
7
OPERATION
Using Keyless Chucks
This tool is equipped with a spindle lock. The
chuck can be tightened with one hand, creat-
ing higher grip strengths on the bit.
Always remove the battery pack or lock the
trigger before inserting or removing bits.
Fig. 1
Sleeve
WARNING
Always lock trigger or remove
battery before changing or removing
accessories. Only use accessories
specifi cally recommended for this
tool. Others may be hazardous.
WARNING
To reduce the risk of injury, wear
safety goggles or glasses with side
shields.
* Cat. No. 2601-20 is not compatible with V™-technology or NiCd systems.
1. To open the chuck jaws, turn the sleeve
in the counterclockwise direction.
When using drill bits, allow the bit to
strike the bottom of the chuck. Center
the bit in the chuck jaws and lift it about
1/16" off of the bottom.
When using screwdriver bits, insert the
bit far enough for the chuck jaws to grip
the hex of the bit.
2. To close the chuck jaws, turn the sleeve
in the clockwise direction. The bit is se-
cure when the chuck makes a ratcheting
sound and the sleeve can not be rotated
any further.
3. To remove the bit, turn the sleeve in the
counterclockwise direction.
NOTE: A ratcheting sound may be heard
when the chuck is opened or closed. This
noise is part of the locking feature, and
does not indicate a problem with the chuck's
operation.