Filter
Top Products
www.norcold.com/cda
44
Refrigerator Service ManualN6XX/N8XX Models
1. Check the condition of the combustion seal.
Replace seal if damaged. Do not install the
refrigerator if the combustion seal is damaged.
2. Place the refrigerator in the enclosure. The
combustion seal must seat fully against the
enclosure wall.
3. Attach the bottom of the cabinet to the enclosure.
See Figure 31.
4. Reinstall the bottom trim piece. See Figure 31.
5. Secure the top of the cabinet with two screws and
install hole plugs. See Figure 32.
6. Secure the back of the cabinet to the enclosure
floor with two screws.
N64XIM/N84XIM (ice maker)
a. Connect the water supply line to the ice maker
water valve.
b. Open the water supply to the ice maker.
7. Connect the RV LP gas supply line to the gas
valve inlet fitting.
8. Open the solenoid gas valve manual shut-off.
9. Plug the refrigerator AC power cord to the RV
receptacle.
10. Connect the RV DC power supply wires to power
board terminals 12VDC and 12V_GND1.
11. Open the LP gas tank valve(s), then leak test LP
gas connection at solenoid gas valve.
12. Leak test the burner solenoid gas valve and orifice
assembly burner tube connections.
!
WARNING
Do not install the refrigerator if the combustion seal
has been damaged. A damaged combustion seal must
be replaced. The seal isolates the living area of the
vehicle from exhaust gases generated by LP gas
combustion. LP gas exhaust gases contain carbon
monoxide, which is an odorless, colorless gas that
can cause dizziness, nausea, or in extreme
concentrations, death
Reinstallation of Refrigerator into Enclosure
Figure 31. Bottom trim and retaining screws.
Figure 32. Top retaining screws and hole plugs.
Cabinet retaining screws
Trim retaining screws
Bottom trim piece
Hole plugs
Cabinet retaining screws