Filter
Top Products
b. Turn the hex head screw clockwise until it stops (do not tighten).
c. Turn the set screw clockwise unt
il it bottoms, then continue for half a turn and check the
tra
, go back to step 4.
blade guide bearing assemblies so that the backside of the blade
ing. If necessary to adjust, go back to step 4.
0. Replace the blade guards.
HE POWER SOURCE
EFORE ATTEMPTING TO SERVICE OR REMOVE ANY COMPONENT.
omponents using SAE-30 oil as noted:
s a week.
ear drive will
s, there is no cause for alarm.
he gearbox:
ear Oil
ure Oil Co. Park Clipper
ROUBLE SHOOTING
cking by turning on the machine,
d. lf further adjustment is required
6. Turn off power to the machine.
7. Replace blade guide assemblies (it may be necessary to loosen the blade tension slightly).
8. Adjust the vertical position of
just touches the ball bearing.
9. Make a final run to check track
1
MAINTENANCE
CAUTION: MAKE CERTAIN THAT THE UNIT IS DISCONNECTED FROM T
B
LUBRICATION
Lubricate the following c
1. BalI-bearing: None.
2. Driven pulley bearing: 6-8 drop
3. Vise lead screw as needed.
4. The drive gears run in an oil bath and will not require a lubricant change more often than once a
year, unless the lubricant is accidentally contaminated or a leak occurs because of improper
replacement of the gear box cover. During the first few days of operation, the worm g
run hot. Unless the temperature exceeds 200 degree
Following lubricants may be used for t
Atlantic Refinery Co. Mogul Cyl. Oil
6
Cities Service Optimus No.
Gulf Refinery Co Medium G
P
T
Page 9 of 15