Filter
Top Products
16
I. PREPARATION
F. Gasoline Engine
Prior to attempting to operate the engine, read the information contained in the engine
owner's manual. An engine owner’s manual is supplied with every gasoline powered
concrete saw.
1. Check Oil: Add oil if low. Refer to the engine owner's manual for the recommended SAE
viscosity grades. Capacity of oil is 1.1 liters (1.16 US qt)
2. Check Fuel: Fill if low. Use only unleaded gasoline with a pump sticker octane rating of 86
or higher is recommended. Never use an oil and gasoline mixture!
3. Air Cleaner: Never run the engine without the air cleaner! Rapid engine wear will result
from contaminants being drawn through the carburetor and into the engine.
4. Engine Starting: Refer to the engine owner's manual for proper engine starting procedure.
Make sure that the Cutting Head Depth Limiting Bolt
Assembly is in the bottom position. The head on the Gasoline
Powered Saw should only rise to a maximum of nine (9) inches
above the surface of the Cutting Table
For any Engine service, warranty, or technical related questions please contact your nearest
Honda service centers:
Honda Power Equipment Group
4900 Marconi Dr.
Alpharetta, GA 30005-8847
Tel: (800) 426-7701 | Fax: (678) 339-2670
Web page: http://www.honda-engines.com/dis.htm