Filter
Top Products
7
I. PREPARATION
B. Assembly
The compact Masonry saws are shipped completely assembled and ready for use except
for diamond blade, gasoline, oil, and Head Locking Bar. Inspect the saw for shipping
damage. If any damage is found, contact the shipper immediately and file a freight claim.
The Norton Company is not responsible for any freight-related damages.
Remove the saw from the pallet.
Items Included with the saw:
Item Part Number QTY
Head Locking Handle 82738 1
Depth Limit Assembly 1
Legs Set of 4 75817 1
Conveyor Cart Assembly 83754 1
Guide-A-Cut Assembly 83892
Water Curtain Assembly 75128 1
Wrench 19 mm 70807 1
Wrench 22mm 72143 1
Water Pump Assembly 72305 1
14” Genuine Norton Diamond Blade for Brick And Block 7499 1
Head Locking Handle:
Remove the Head Locking Screw from the machine (see Figure: Head Locking Screw
Removal). Replace the Head Locking Screw with the Head Locking Handle located in the
plastic bag of accessories (see Figure: Head Locking Handle Installation). Read and
understand the remaining sections of this Owners Manual.
The Head Locking Handle is used to lock the cutting head at a set position or depth of cut.
The Head Locking Screw is only used to hold the Cutting Head of the machine in place at
the Norton Company Factory.
Do not install the blade until it is time to use the saw!
ANSI regulations prohibit the transportation of any concrete
saw with the blade installed!