Filter
Top Products
16
Insure that the operator is familiar with the control and gauge
locations and functions before proceeding:
Control and Gauge locations and function Chart
Item Type Function
Engine Control Module
w/Hour Meter
Control Starts Engine, LED warning indicators and will
shut the engine down in the event of low oil,
over temperature, engine over speed.
Depth Lock Control Allows operator to cut at a preset depth
Depth Gauge Control Indicates cutting depth
Vernier Throttle Control Precise Engine speed control. Pull out or twist.
Raise/Lower Switch Control Raise or lower blade into work surface. To
Raise move the switch to the rear of the saw.
To lower move the switch forward.
Emergency Kill Switch Control Kills Engine when activated
Forward/Reverse Lever Control Controls direction and speed of machine
Transmission
Engage/Disengage
Lever
Control Engages or Disengage Transmission. NOTE:
Only Engage the Transmission when the
Forward/Reverse Lever is in the Neutral
Position. Engaging the Transmission when the
Forward/Reverse Lever is not in the Neutral
Position can damage the Transmission
Jackshaft Gear
Ignition Power Key
Switch
Control Energize Engine/Engine Gauge system and
Accessory Control System. Turns the machine
off.
Fuel Cap w/Gauge Gauge Shows current fuel level
12-volt Power Point Control Auxiliary power source for 12-volt accessories
such as: Light Kit. Can be used to charge a cell
phone
Fuse Control Left side fuse protects the Accessory systems.
Right side fuse protects the Engine Control
System. All fuse are
AGC Type Fuse 1/4" DIA x 1-1/4" Long, 15A
Optional Water Pump
Switch
Control Controls optional Water Pump. NOTE: All
machines will have the switch installed at the
factory. The water pump is a dealer installed
option.
Blade Saver Switch Control Activates the Blade Saver Switch (Water
Pressure Switch) System. When activated the
Blade Saver Switch will shut the engine off if
low water pressure is used.