Omega Speaker Systems 1200W Router Router User Manual


 
Helpline No. UK / Northern Ireland 0870 7323023 • Rep. Ireland 1800 481005
Web Support: www.omegawolf.com/powercraft
Model Number:
PBF-1200 15
Operation
depth is set correctly, the groove in question can be routed accurately to within 0.1
mm.
Preparation:
Place the desired cutter in the tool.
Loosen the clamping lever (11). The router can then be pushed down against
the spring force.
Push the tool down until the cutter touches the workpiece, then relock it
using the clamping lever (11).
Loosen button 9 (counter-clockwise).
Set button 15 to zero.
Use button 8 to set the depth all the way down.
Tighten button 9 (clockwise). The plunge depth is now set to precisely 0 mm.
Rough setting:
Read the value from the scale (12).
Loosen button 9 (counter-clockwise).
Turn button 8 and re-read the value from the scale. The difference between
the two values is the plunge depth setting. For example: If the value on the
scale (12) is 8.5 in the zero-setting and the value is 7.0 after button (8) has been
turned, then the plunge depth has been set to 1.5 cm.
Retighten button 9 (clockwise).
Fine adjustment:
Loosen button 9 (counter-clockwise).
The top button (15) is still set to zero. Give this button a full counter-clockwise
turn, until it is back in the zero position. The plunge depth is now 1.0 mm less.
If required, the plunge depth can be set accurately to within 0.1 mm.
Retighten button 9.
Adjustment using the r
evolver- depth stop
The revolver-depth stop enables you to quickly choose between six different cut-
ting depths. These are also determined by the adjustment of the depth stop (10).
Adjust the required cutting depth by rotating the revolver-depth stop (21).
Helpline No. UK / Northern Ireland 0870 7323023 • Rep. Ireland 1800 481005
Web Support: www.omegawolf.com/powercraft
Model Number:
PBF-1200 06
Safety instructions
The following symbols are used in these instructions for use:
Read the instructions carefully.
Conformity with the relevant EU safety directives.
Class II machine - double insulation - earth connection not required.
Danger of life and risk of injury as well as risk of damage to the
machine in case of non-adherence to the safety instructions in
these instructions of use.
Danger of electric shock.
Remove the plug from the mains socket.
Variable speed control
Wear ear and eye protection
Faulty and/or discarded electrical or electronic machines have to be
collected at the appropriate recycling locations.
General safety instr
uctions
Caution! Read all instructions. The non-observation of the instructions
mentioned below may cause an electric shock, fire and/or severe injuries. The
term “electric tool” mentioned below refers to mains-operated electric tools
(with power cord) and to rechargeable electric tools (without power cord).
Keep these instructions for use in a safe place.
1) Workplace
(a) Keep your workplace clean and tidy. Untidy and badly illuminated work
areas may lead to accidents.