Filter
Top Products
BUTTON SELECTION SUBMENU:
Press d 12) Display flashes previous selection of
GROS
Gross or
PEAK
Peak.
Press b 13) Scroll through the available selection
GROS
or
PEAK
to the
selection of your choice.
Press d 14) Display shows
STRD
stored message momentarily and then
advances to
RDG
Reading Configuration Menu.
If
GROS
was selected, in the Run Mode pressing
b
button causes the
display to flash Gross value (value measured without zeroing of the
display).
If
PEAK
was selected, in the Run Mode pressing
b
button causes the
display to flash Peak value.
0 - 20 mA current input used for process control only.
For 4 - 20 mA Input select 0 - 20 mA and adjust the Input/Reading
accordingly. To adjust 4 - 20 mA input, see example under
INPUT/READING Submenu.
3.2.5 Reading Configuration Menu
Figure 3.4 Flow Chart for Reading Configuration Menu
19
It is required that you put the controller in the Standby Mode
for any configuration change other than Set Points & Alarms.