Filter
Top Products
Introduction
8 900-0112-01-00 Rev A
System Display and Controller
The GFX inverters have no external controls. They can operate normally without an external control or
interface. Basic modes and settings are pre-programmed at the factory. However, if the
pre-programmed settings need adjustment, a remote system display must be used for changing those
settings and for more detailed monitoring activities. Modes and settings cannot be changed without
the system display.
The MATE Series Display and Controller is an OutBack system display, available for remotely
interfacing with the GFX series inverters.
IMPORTANT:
The GFX inverters have nonvolatile memory and will retain any settings that
have been changed, even after the system display is removed. If a system
does not have a display, an installer can bring a system display to the site
temporarily, install it, change the settings, and remove the display again.
IMPORTANT:
Some functions are not based in the inverter, but are part of the system
display’s software. They will not function if the system display is removed.
These functions are listed on page 28. For a detailed description and
programming, please see the manual for the system display.