Filter
Top Products
Ref.No.2D Procedure 2A →
→→
→ 2B →
→→
→ 2C →
→→
→ 2D Assembly of the Adjusting Screw and the Clutch
Handle.
Fig.8
1. Align the mark of adjusting screw with the projection (A) of
driving block.
2. Turn the adjusting screw into the driving block about one
rotation for clockwise direction.
3. Align the hollow (A) of adjusting screw with the projection (A) of
driving block.
4. Set the clutch handle with position 1 on top. (Aligh the position 1
of clutch handle with the projection (A) of driving block.)
5. Insert the clutch handle with adjusting the tabs of adjusting
screw to the groove of inside clutch handle.
6
EY6105-U1