Filter
Top Products
Ref. No. 2D Procedure 2A →
→→
→ 2B →
→→
→ 2C→
→→
→ 2D Attachment of driving block.
For assembling
1. Set the jig (bearing cap) into the clutch case and hold it with a
vise in order to take out the bearing.
2. Assemble the bearing with the spindle assembly.
3. Set the snap ring.
NOTE :
It has own direction for reassembly. Place the rounded face of
snap ring to the clutch case side.
4. Fit O-ring onto the bearing.
5. Assemble the chuck spring and the chuck spring plate.
6. Insert a ball pushing down the chuck spring.
7. Insert the reciprocation bearing shaft into the hole of universal
coupling. Make sure two thrust plates should be set both side of
reciprocation bearing shaft one of each.
NOTE :
Apply grease especially for the connection area between
reciprocation bearing and universal coupling. In addition,
hammer O-ring, inside of piston and cylinder for output shaft
block also need to apply.
Air compressed by the piston drives hammer. Take care to
protect the piston and hammer from contamination by dust.
6
EY6803-U1