Filter
Top Products
9
Ref. No. 2B Procedure 2A → 2B Assembly of Gear box assembly.
1. Insert the driving carrier into the hole of gear case assembly and
the driving hammer assembly.
2. Hold the driving carrier as illustrated and confirm if the connect
piece is inside of the driving shaft block.
3. Insert the pin into the shaft of driving carrier holding the bottom of
the gear box assembly by hand.
4. Align the wider groove of revolving stand with the wider protrusion
of gear case.
5. Assemble the ring gear into the revolving stand and set it on the
motor assembly.
6. Place fit the hole of driving carrier and the pins of revolving stand.