Panasonic EY7960 Drill User Manual


 
-
8
-
Attaching or Removing Bat-
tery Pack
1.
To connect the battery pack:
Line up the alignment marks and at-tach
the battery pack.
Slide the battery pack until it locks into
position.
Alignment marks
2.
To remove the battery pack:
Push on the button from the front to re-
lease the battery pack.
Button
Support handle
Place the support handle at your favorite
position and tighten the handle securely.
Tighten
Loosen
Remove the handle when placing the
tool in the storage case.
VI. OPERATION
[Main Body]
Switch Operation
1. The speed increases with the
amount of depression of the trigger.
When beginning work, depress the
trigger slightly to start the rotation
slowly.
2. A feedback electronic controller is
used to give a strong torque even
in low speed.
3. The brake operates when the trig-
ger is released and the motor stops
immediately.
NOTE:
When the brake operates, a brak-
ing sound may be heard. This is
normal.
Switch and Forward/Reverse
Lever Operation
Forward Reverse
Switch lock
CAUTION:
To prevent damage, do not operate
Forward/Reverse lever until the bit
comes to a complete stop.
Forward Rotation Switch
Operation
1. Push the lever for forward rotation.
2. Depress the trigger switch slightly
to start the tool slowly.
3. The speed increases with the
amount of depression of the trigger
for efficient tightening of screws and
drilling. The brake operates and the
chuck stops immediately when the
trigger is released.
4. After use, set the lever to its center
position (switch lock).
Reverse Rotation Switch
Operation
1. Push the lever for reverse rotation.
Check the direction of rotation
before use.
2. Depress the trigger switch slightly
to start the tool slowly.