Filter
Top Products
-
12
-
3. Press the OK button to accept the select-
ed setting.
•
The control panel will stop flashing and
light up.
Checking Tool Settings
•
This section describes how to have the
tool display current settings for approx-
imately 3 seconds when the tool is
stopped.
•
You cannot check tool settings when the
control panel is turned off. First, engage
the switch briefly to reactivate the display.
Checking the torque clutch setting
1.
Press the torque set button.
• Control panel display
Display: The torque set lights up.
Battery indication lamp: The upper bar of
the battery ashes on and off.
Checking the interval
1.
Press the interval set button.
• Control panel display
Display: The interval set lights up.
Battery indication lamp: The middle bar
of the battery ashes on and off.
Checking tool circuits
1.
Press the torque set button.
• Control panel display
Display: The torque set display lights up.
Battery indication lamp: The middle and
lower bars of the battery ash on and off.
Display Tool circuit
H2 EYFLA1
H3 EYFLA
2
H4 EYFLA3
NOTE:
•
If you engage the switch while a setting
is being displayed, the control panel will
revert to the torque clutch setting dis-
play.
CAUTION:
•
The torque set display is not intended
to be used to identify the type of drive
component parts (hammer, etc.) used
in a particular tool.