Parkside PBS 600 A1 Sander User Manual


 
11 GB/IE
Preparing for use / Operation
Connection:
˽ Push the adapter for external vacuum extraction
12
into the adapter port
9
. If it is necessary to
use the reducer piece
13
, push the reducer piece
into the adapter for external vacuum extraction
12
.
˽ Slide the hose of a suitable dust extraction de-
vice approved for that purpose (e.g. a workshop
vacuum cleaner) on to the adapter for external
vacuum extraction
12
with the reducer piece
13
,
if used.
Removal:
˽ Pull off the dust extraction device hose.
˽ Pull off the adapter for external vacuum extrac-
tion
12
(with the reducer piece
13
, if used).
©
Operation
©
Switching on and off
When operating the belt sander you can select
between intermittent or continuous operation mode.
To switch on intermittent operation mode:
˽ Press the ON / OFF switch
3
.
To switch off intermittent operation mode:
˽ Release the ON / OFF switch
3
.
To switch on continuous operation mode:
˽ Press the ON / OFF switch
3
, and keep it
pressed, then press the locking knob
4
.
To switch off continuous operation mode:
˽ Press and then release the ON / OFF switch
3
.
©
Selecting the correct rotational
speed and sanding belt
You can select the belt speed using the belt speed
adjuster wheel
1
even whilst the sander is running.
The optimum belt speed depends on the workpiece
and the workpiece material. Always confirm the best
speed by carrying out a small test. The following
table lists some recommended values to help you
determine the optimum speed.
Material / type of
work
Softwood
Coarse finish
(Grit grade)
60
Fine finish (Grit grade) 240
Preselected rotation
speed
high (5-6)
Material / type of
work
Hardwood
Coarse finish
(Grit grade)
60
Fine finish (Grit grade) 180
Preselected rotation
speed
high (5-6)
Material / type of
work
Chipboard
Coarse finish
(Grit grade)
60
Fine finish (Grit grade) 150
Preselected rotation
speed
high (5-6)
Material / type of
work
Removing paint /
varnish
Coarse finish
(Grit grade)
60
Fine finish (Grit grade) ––
Preselected rotation
speed
high (5-6)
Material / type of
work
Sanding varnish
Coarse finish
(Grit grade)
150
Fine finish (Grit grade) 320
Preselected rotation
speed
low (1-2)