Filter
Top Products
14 GB/IE
Operation
Switching on:
˽ Press the ON / OFF switch
1
.
Switching off:
˽ Release the ON / OFF switch
1
.
©
Setting the stroke rate
The stroke switch
2
is used to set the penetration depth of the engrav-
ing. A low setting is normally adequate for most engraving tasks.
˽ Turn the switch for the number of strokes
2
in the + direction to
increase the penetration depth.
˽ Turn the switch for the number of strokes
2
in the – direction to
decrease the penetration depth.
©
Changing the engraving point
WARNING!
RISK OF INJURY! Switch the device off before
performing any tasks on the device and pull the mains plug out of the
mains socket.
˽ Replace the engraving point
5
as soon as it becomes too worn
and no longer provides the desired engraving performance. Turn
the engraving point holder
6
anticlockwise until the engraving
point
5
is released.
˽ Insert a new engraving point
5
and turn the engraving point
holder
6
clockwise to lock the engraving point in position.
˽ Ensure that the engraving point
5
is properly fixed in position.