Filter
Top Products
14 GB/IE/CY
Operation
Q
Operation
The mains voltage must correspond with that shown on the sander rat-
ing plate. Equipment labelled as 230 V may also be used with 220 V.
Q
Switching on and off
Switching on:
j Insert the mains plug into a suitable mains socket.
Switching off:
j Pull the plug out of the mains socket to switch off the device.
Q
Third hand
CAUTION! DANGER OF BURNS! The clips
5
on the
third hand
6
can become hot while you are soldering the
workpiece.
1. Fold out the third hand
6
upwards.
2. Rotate the clips
5
until they are oriented in the required direction.
3. Clamp the workpiece between the two clips
5
.
Q
Solder sponge
CAUTION! The hot soldering tip
2
must never be placed in
contact with a dry solder sponge
8
, otherwise the solder sponge
may be damaged.
j The solder sponge
8
is used to clean soldering tips.
j Moisten the solder sponge
8
before you use it.
33381_Content_LB6.indd 14 08.06.09 13:08