Filter
Top Products
SmartNode 4660 & 4670 Quick Start Guide 3
1.0 Power up the SmartNode
1. Connect the SmartNode to a power source using the included power supply and cable.
2. When the Power LED stops blinking and remains lit, the SmartNode is ready to configure.
2.0 Configuring your SmartNode
Refer to the SmartNode 4660 & 4670 Series User Manual available online at www.patton.com/manuals/
SN4660-SN4670.pdf for detailed information about:
•
Installing, configuring, operating, and troubleshooting the SmartNode
•
Warranty, trademark & compliance
This device contains no user serviceable parts. This device can only be
repaired by qualified service personnel.
Cet appareil contient des pièces n'est réparable par l'utilisateur. Ce dis-
positif ne peut être réparé par du personnel qualifié.
In accordance with the requirements of council directive 2002/96/EC on Waste of
Electrical and Electronic Equipment (WEEE), ensure that at end-of-life you separate
this product from other waste and scrap and deliver to the WEEE collection system in
your country for recycling.
Electrostatic Discharge (ESD) can damage equipment and impair electrical
circuitry. It occurs when electronic printed circuit cards are improperly
handled and can result in complete or intermittent failures. Do the follow-
ing to prevent ESD:
• Always follow ESD prevention procedures when removing and replac-
ing cards.
• Wear an ESD-preventive wrist strap, ensuring that it makes good
skin contact. Connect the clip to an unpainted surface of the chassis
frame to safely channel unwanted ESD voltages to ground.
• To properly guard against ESD damage and shocks, the wrist strap
and cord must operate effectively. If no wrist strap is available,
ground yourself by touching the metal part of the chassis.
WARNING
CAUTION