Filter
Top Products
4 OnSite 2621 & 2635 Quick Start Guide
2.2 Modify the IP address
1. Display current IP interface settings for the OnSite Ethernet LAN port.
fi
ip list interfaces <enter>
IP Interfaces:
ID | Name | IP Address | DHCP | Transport
---|------|----------------|----------|--------------
1 | ip1 | 192.168.200.10 | disabled | eth0
----------------------------------------------
------
2. Modify the IP address for the LAN port according to your network requirements.
fi
ip set interface ip1 ipaddress 10.10.10.5 255.255.255.0
Note The above IP address (
10.10.10.5/24)
is only an example. You must choose an IP address on the same
subnet as your PC.
3. Verify the new address is correct and save it in non-volatile memory.
fi
ip list interfaces <enter>
fi
system config save <enter>
fi
Now you can connect the OnSite to your local IP network and complete the remaining configuration from your
PC using a standard web browser.
3.0 Connect to the local IP network
Connect the OnSite’s (green) Ethernet port to the same Ethernet segment as your PC (see figure 2). Press the
MDI-X switch until the Ethernet Link LED turns on.
Figure 2. Connecting the OnSite to the local IP network
You can check the network connection with the ping command. For example, you would ping 10.10.10.5 from
your PC.
MDI-X
Crossover
10/100
Ethernet
Power
X.21 Interface
Connect to Ethernet port
Ethernet port
MDI-X switch
PC