14 Pelco Manual C2434M (7/01)
SPECIFICATIONS
MECHANICAL
Construction
Back box: Aluminum
Dome drive: Aluminum, ABS plastic
Lower dome: Acrylic
Cable Entry
In-Ceiling: .75-inch (1.91 cm) conduit fitting
Pendant: Through 1.5-inch (3.81 cm) NPT pendant mount
Pan Movement: 360° continuous pan rotation
Vertical Tilt: Unobstructed +2° to -92°
Manual Pan/Tilt Speeds*
Pan: 0.1-80° /sec manual operation, 150° /sec turbo
Tilt: 0.1-40° /sec
Preset Speeds
Pan: 250° /sec
Tilt: 200° /sec
* For variable-speed operation an appropriate controller is required. With fixed-speed
controllers, pan/tilt speed is 24°/sec. The CM6700 controller with the KBD200 keyboard
has programmable fixed speeds.
ELECTRICAL
Input Voltage: 18-30 VAC, 24 VAC nominal
Input Power: 30 vA nominal (indoor, w/o heater)
75 vA nominal (outdoor, with heater)
Fuse: 1.6 A
Relay Contacts AUX 1 AUX 2 Output
Type: Form C Open collector transistor output
Voltage: Low voltage (<40 V) 32 VDC maximum
Current: 2 A maximum 150 mA maximum
CAMERA
Signal Format: NTSC (model DD5BCBW)
Scanning System: 2:1 interlace
Image Sensor: 1/4-inch interline transfer CCD
Effective Pixels: 768 (H) x 494 (V)
Horizontal Resolution: >470 TV lines
Lens Minimum f-stop: F1.4
Focal Length: 4.1 mm to 73.8 mm optical
Zoom Ratio: 18X optical zoom, 4X electronic zoom
Digital Slow Shutter: Auto/manual speed selection
Horizontal Angle of View: 48° (at 4.1 mm wide zoom), 2.7° (at 73.8 mm telephoto zoom)
MTBF: >500,000 cycles at room temperature (zoom, focus, irs)
Focus: Automatic and manual override
Sensitivity: . 2 lux at 1/4-second shutter speed (color)
.2 lux at 1/60-second shutter speed (black & white)
Sync System: AC line lock, phase adjustable via remote control*
White Balance: Automatic with manual override*
Shutter: Speed Automatic (electronic iris)/manual
1/4 to 1/10,000*
Iris Control: Automatic with manual override*
Gain Control: Automatic with manual override*
Video Output: 714V ± .07V (100 IRE ± 10 IRE)
Signal to Noise Ratio: >46 dB
* Manual control of camera setup functions can be done with CM6700, CM6800, CM8500,
CM9500, CM9740, CM9760 and MPT9500 controllers, but not with CM7500, MPT9000
or KBD9000 controllers.