Filter
Top Products
4
SPECIFIC SAFETY RULES AND SYMBOLS
1. Hold tool by insulated gripping surfaces when performing an
operation where the sanding tool may contact hidden wiring or its own
cord. Contact with a “live” wire will also make exposed metal parts of the tool
“live” and shock the operator.
2. Keep hands and body parts away from rotating spindle. Contact with
rotating spindle can cause severe cuts and abrasions.
3. Use proper safety equipment. Wear safety goggles to protect your eyes,
wear hearing protection to protect your ears, and wear a protective mask to
minimize breathing in the fine dust created while sanding.
4. Sanding of lead-based paint is not recommended. Lead-based paint
should only be removed by a professional.
5. Always keep the base of the sander in contact with a secure
workpiece to prevent loss of control.
6. Do not operate Oscillating Sander without all guards and covers
securely in place.
7. Some wood contains preservatives which can be toxic. Take extra
care to prevent inhalation and skin contact when working with these materials.
Request, and follow, any safety information available from your material
supplier.
8. WARNING: There are certain applications for which this tool was
designed. Porter-Cable strongly recommends that this tool NOT be modified
and/or used for any application other than for which it was designed. If you
have any questions relative to its application DO NOT use the tool until you
have written Porter-Cable and we have advised you.
Technical Service Manager
Porter-Cable Corporation
4825 Highway 45 North
Jackson, TN 38305
SYMBOL DEFINITION
V ........................ volts
A ........................ amperes
Hz ........................ hertz
W ........................ watts
kW ........................ kilowatts
µF ........................ microfarads
l ........................ liters
kg ........................ kilograms
N/cm
2
........................ newtons per square centimeter
Pa ........................ pascals
h ........................ hours
min ........................ minutes
s ........................ seconds
........................ alternating current
3 ........................ three-phase alternating current
3
N ........................ three-phase alternating current with neutral
........................ direct current
899604 - 03-08-02.qxd 3/18/02 9:12 AM Page 4