Porter-Cable 17-925 Drill User Manual


 
7
ASSEMBLY
FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL THE
MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE INSTRUCTION
MANUAL.
1. Assemble the column (A) Fig. 3, to the base (B) using
the four M10x40mm hex head screws (C), three of which
are shown. Loosen set screw (D) with 3mm wrench
supplied, and remove ring (E) and raising rack (F).
2. Insert small end of worm gear (G) Fig. 4 and Fig. 5,
through hole (H), from the inside of the table bracket.
Make certain that the worm gear engages the internal
gear in the table bracket.
3. Insert raising rack (F) Fig. 6, which was removed in
STEP 1, into groove in table bracket (I) making sure
teeth of internal gear, located inside table bracket, are
engaged with teeth of raising rack (F).
Fig. 3
Fig. 4
Fig. 5
Fig. 6
G
H
G
H
F
I
A
B
C
D
E
F