Filter
Top Products
11
Fig. 2
Fig. 3
Models 333 and 333VS:
1. DISCONNECT TOOL FROM POWER SOURCE.
2. Place machine on workbench with pad up (see Fig. 3).
3. Clean dust from pad face.
4. Position Hook & Loop Abrasive Disc onto sander pad, aligning the dust
extraction holes in paper with holes in pad. NOTE: When using 8-hole
abrasive on model 333VS, align the hole pattern in the abrasive with the
groove in the sander pad.
Do not use PSA (Pressure Sensitive Adhesive) disc
with Hook & Loop pad as the disc may be thrown from the pad
causing personal injury.
5. Press disc firmly onto pad.
Failure to properly seat disc to pad may result in disc
being thrown from pad causing personal injury.
6. To remove disc, peel disc away from pad.
DUST COLLECTOR (Models 333, 333VS and 334)
1. DISCONNECT TOOL FROM POWER SOURCE.
2. Position dust collector to sander nozzle as shown in Fig. 4. Seat
collector onto nozzle.
3. Periodically remove dust container from flange and empty collected
dust, Fig. 5.
NOTE: A slight twisting action will ease removal and reassembly.
Tap container lightly to remove compacted dust. DO NOT WASH
CONTAINER. Dry compressed air may be used to blow out container.
Fig. 4
DUST
COLLECTOR
NOZZLE