Filter
Top Products
9
CUTTINGHEAD AND CROSS-CUT
STOP TO TRACK-ARM
1. Remove two screws (A) and end cap (B) from track-
arm, Fig. 8.
2. Hold cuttinghead assembly (D) Fig. 9, with both
hands and insert the ball bearings (E) into the track-
arm, as shown. Push cuttinghead all the way onto
track-arm and tighten clamp knob (F).
3. Assemble cross-cut stop (C) to the track-arm (Fig.
10).
4. Replace end cap (B) that was removed in STEP 1
(Fig. 11).
F
D
E
Fig. 8
Fig. 9
Fig. 10
Fig. 11