Filter
Top Products
10
The saw can now be adjusted for a bevel cut between the normal stop (45°
or 90°) and 3° beyond the normal stop.
5. Position saw to desired angle and firmly tighten bevel adjustment knob.
NOTE: The bevel stop sleeve must be returned to the normal
position (see Fig. 6), before the saw can be adjusted for a bevel cut
of between 45° and 90°.
TO ADJUST 90° POSITIVE STOP
1. CAUTION: DISCONNECT TOOL FROM POWER SOURCE.
2. Set bevel stop sleeve to normal position (see Fig. 6).
3. Loosen bevel adjustment knob (A) Fig. 5, and position base for 90° cut
being sure that the bevel stop sleeve is against the 90° stop screw.
4. Turn saw upside down, retract telescoping guard and check squareness
of blade as shown in Fig. 7.
5. If adjustment is necessary loosen bevel adjustment knob, keeping bevel
stop sleeve in contact with stop screw, turn stop screw until squareness is
obtained.
TO ADJUST 45° BEVEL POSITIVE STOP
1. CAUTION: DISCONNECT TOOL FROM POWER SOURCE.
2. Set bevel stop sleeve to normal position (see Fig. 6).
3. Loosen bevel adjustment knob (A) Fig. 5, and position base for 45° cut
being sure that the bevel stop sleeve is against the 45° stop screw.
4. Turn saw upside down, retract telescoping guard and check 45° angle
as shown in Fig. 8.
5. If adjustment is necessary loosen bevel adjustment knob and turn stop
screw until angle is correct.
Fig. 7 Fig. 8
A
C
B
D
Fig. 6 Fig. 6A
900003 - 04-09-02.qxd 4/18/02 7:41 AM Page 10