Filter
Top Products
8
ADJUSTING DEPTH OF CUT
1. CAUTION: DISCONNECT TOOL FROM POWER SOURCE.
2. Loosen clamp screw (A) Fig. 3.
3. While holding base (E), turn motor unit (F), Fig. 3, COUNTERCLOCKWISE
until the tip of the bit is above bottom surface of base.
4. Set router on flat wood surface.
5. Turn motor unit (F), Fig. 3, CLOCKWISE until bit touches the wood
surface.
6. Tighten clamp screw (A) Fig. 3.
7. Rotate depth adjusting ring (B), Fig. 3, until the zero-line (C) is opposite
the index line (D) on the housing.
8. Loosen clamp screw (A), Fig. 3.
9. Tip the router so bit is clear of the wood surface. Turn motor unit (F),
Fig. 3, CLOCKWISE until the index line (D) on the motor housing reaches the
desired depth indicated on the ring.
10. Tighten clamp screw (A), Fig. 3, firmly.
NOTE: Setting the index line to
1
/4" on the ring means the cutting
edge of the bit is exposed
1
/4" below the base.
CONNECTING TO POWER SOURCE
CAUTION: Before connecting router to power source ALWAYS
MAKE SURE SWITCH IS IN THE “OFF” POSITION. Also check that
the power circuit is the same as that shown on specification plate of
the router.
Fig. 3
A
B
F
D
C
E
899750 - 02-14-02.qxd 9/24/02 7:43 AM Page 8