Filter
Top Products
12
HOW TO HOLD THE HAMMER DRILL/DRIVER
The front end of the Hammer Drill/Driver may be made live
if the tool drills into live wiring in the wall. TO PREVENT
ELECTRICAL SHOCK, THE HAMMER DRILL/DRIVER
MUST BE HELD AS SHOWN IN FIG. 10B.
GENERAL DRILLING
1. Set torque adjusting collar for drilling operation and set speed selector to
appropriate speed.
2. Be sure drill bit is securely gripped in chuck.
3. Set REVERSING BUTTON for clockwise rotation.
Make sure work is held securely in vise or clamped in place
prior to starting drilling operation. Loose work may spin and
cause bodily injury.
4. Locate exact center for hole to be drilled, and use a center punch to make
a small dent in work.
5. Place tip of drill bit in dent made by center punch, hold drill square with
work, and start the motor.
Applying too much pressure may cause the bit to overheat or
break resulting in bodily injury or damaged drill bits.
Apply steady, even pressure to keep drill bit cutting. Too little pressure will keep
the bit from cutting and dull the cutting edges due to excessive friction created
by sliding over the surface.
Always be alert and brace yourself against the twisting action
of the drill.
6. If drill stalls or becomes jammed in the hole, release trigger immediately,
remove drill bit from work, and determine cause of stalling or jamming. DO
NOT SQUEEZE TRIGGER ON AND OFF IN AN ATTEMPT TO FREE A STALLED
OR JAMMED DRILL – THIS WILL DAMAGE THE MOTOR.
The direction of rotation may be reversed to help free a jammed bit. Be sure
direction of rotation is RESET before attempting to continue drilling.
7. Reduce the pressure on the drill just before the bit cuts through the work
to avoid splintering wood or stalling in metal.
8. When bit has completely penetrated work and is spinning freely, withdraw
it from the work while the motor is still running, then turn off drill.
IT’S A
HAMMER DRILL
Fig.. 10B