Filter
Top Products
6
1. Hold power tools by insulated gripping surfaces when performing an
operation where the cutting tool may contact hidden wiring or its own
cord. Contact with a "live" wire will make exposed metal parts of the tool
"live" and shock the operator.
2. Use clamps or other practical way to secure and support the
workpiece to a stable platform. Holding the work by hand or against your
body is unstable and may lead to loss of control.
3. Disconnect tool from power source before making adjustments or changing bits.
4. Tighten Collet nut securely to prevent the bit from slipping.
5. Provide clearance under workpiece for router bit when through-cutting.
6. Check to see that the cord will not “hang up” during routing operation.
7. Clear the router bit area before starting motor.
8. Maintain firm grip on router to resist starting torque.
9. Keep hands clear of bit when motor is running to prevent personal injury.
10. Keep cutting pressure constant. Do not overload motor.
11. Let the motor come to a complete stop before putting the tool down.
12. Never touch router bits after use. They may be extremely hot.
13. Never tighten collet nut without a bit.
14. Do not use router bits with a diameter in excess of 2-1/2" at RPM above 13,000.
Router bits up to 3-1/2" in diameter can be used when speed control is set for 13,000
RPM or less.
15. Always keep chip shield clean and in place.
16. Avoid “Climb-Cutting” (see “Using The Router” section in this manual). “Climb-
cutting” increases the chance for loss of control resulting in possible personal injury.
17. Wear eye and hearing protection. Always use safety glasses. Everyday
eyeglasses are NOT safety glasses. USE CERTIFIED SAFETY
EQUIPMENT. Eye protection equipment should comply with ANSI Z87.1
standards. Hearing equipment should comply with ANSI S3.19 standards.
18. Use of this tool can generate and disburse dust or
other airborne particles, including wood dust, crystalline silica dust
and asbestos dust. Direct particles away from face and body. Always
operate tool in well ventilated area and provide for proper dust removal.
Use dust collection system wherever possible. Exposure to the dust may
cause serious and permanent respiratory or other injury, including silicosis
(a serious lung disease), cancer, and death. Avoid breathing the dust, and
avoid prolonged contact with dust. Allowing dust to get into your mouth or
eyes, or lay on your skin may promote absorption of harmful material.
Always use properly fitting NIOSH/OSHA approved respiratory protection
appropriate for the dust exposure, and wash exposed areas with soap and
water.
ADDITIONAL SPECIFIC SAFETY RULES
SAVE THESE INSTRUCTIONS!