Porter-Cable C7501M Air Compressor User Manual


  Open as PDF
of 80
 
8 - ENGN020206
ACCESSORIES
Accessories for this unit are available at the store the unit was purchased.
The use of any other accessory not recommended for use with
this tool could be hazardous. Use only accessories rated equal to or higher
than the rating of the air compressor.
ASSEMBLY
TOOLS REQUIRED FOR ASSEMBLY
1 - 9/16" socket or open end wrench
1 - Electric Drill
UNPACKING
1. Remove all packaging.
It may be necessary to brace or support one side of the outfit when
removing the pallet because the air compressor will have a tendency to tip.
2. Remove and discard the (4) screws and washers holding the compressor to
the pallet.
3. Withthehelpofanotherpersoncarefullyremoveaircompressorfrompallet
and place on a level surface.
This compressor was shipped with oil in the pump crankcase.
Check oil before operating air compressor, see Check Oil under Maintenance.
INSTALLATION
LOCATION OF THE AIR COMPRESSOR
• Locatetheaircompressorinaclean,dry,andwellventilatedarea.
• Located the air compressor at least 12" (30.5cm) away from the wall or
other obstructions that will interfere with the flow of air.
• Locatetheaircompressorasclosetothemainpowersupplyaspossibleto
avoid using long lengths of electrical wiring. NOTE: Long lengths of electrical
wiring could cause power loss to the motor.
• Theairfiltermustbekeptclearofobstructionswhichcouldreduceairflow
to the air compressor.
ANCHORING OF THE AIR COMPRESSOR
Risk of bursting. Excessive vibration can weaken the air tank
and cause an explosion. The compressor must be properly mounted.
The air compressor MUST be bolted to a solid, level surface.
Hardware needed:
4 - Concrete anchors (not supplied)
4 - 3/8" Lag screw to fit concrete anchors (not supplied)
4 Washers
(found in parts bag)
- shims (if needed)
1. Place the air compressor on on a solid, level surface.
2. Mark the surface using the holes in the air compressor feet as a template.
3. Drill holes in the surface for the concrete anchors. Install concrete anchors.
4. Line-up holes in surface with holes in air compressor feet.
5. Place the (4) washers (supplied) between the floor and air compressor feet. If
needed, solid shims may be placed between the washers and floor to evenly
distribute weight on all four feet. See next figure.
 previous next