Filter
Top Products
4
1. Read and understand tool labels and
manual. Failure to follow warnings could
result in DEATH or SERIOUS INJURY. Fig. 1.
2. Operator and others in work area MUST
wear safety glasses with side shields.
These safety glasses must conform to ANSI
Z87.1 requirements (approved glasses have
“Z87” printed or stamped on them). Fig. 2.
3. Keep fingers AWAY from
trigger when not driving fasteners to
avoid accidental firing.
4. Choice of triggering method is
important. Check manual for triggering
options. See “Using the Tool with
Selectable Triggering Options” section of
this manual.
5. Never point tool at yourself or others
in work area. Fig. 3
6. Never use oxygen or
other bottled gasses. Explosion may
occur. Never use combustible gases or any
other reactive gas as a power source for
this tool: explosion and serious personal
injury could result. Fig. 3 & Fig. 4.
7. Wear ear protection to safe-guard
against possible hearing loss. Ear
protection equipment must conform to ANSI
S3.19 requirements. Fig. 5.
8. Use clean, dry, regulated, com-
pressed air at 70 to 120 PSI, (4.8 to 8.3
BAR). Fig. 6.
Fig. 6
Fig. 5
Fig. 2
Fig. 3
Fig. 4
Fig. 1
GENERAL SAFETY RULES