Filter
Top Products
9
ASSEMBLY
ANTI-SPLINTER BASE INSERT INSTALLATION
The anti-splinter base insert is used to
reduce chipping and splintering of the
top fibers of plywood, paneling, and
other splinter prone materials. When this
insert is used it is not necessary to have
the good or finished side of the work
down during the cutting operation.
Install the insert as shown in Fig. 1.
NOTE: When using the anti-splinter
insert, the base should be set to the
forward most position, Fig. 9.
ANTI-MAR PLASTIC SUB-BASE INSTALLATION
DISCONNECT TOOL FROM POWER SOURCE.
The anti-mar plastic sub-base is used when cutting on finished surfaces to
prevent the normal metal base from scratching, gouging, or otherwise
marring the surface of the material to be cut.
To install the plastic sub-base, remove the six screws from the bottom of the
base, remove the metal sub-base, place the plastic sub-base on the saw, and
reinstall the six screws. Be sure to save the metal sub-base for reuse.
BLADE INSTALLATION
1. Remove anti-splinter insert if installed.
2. Gently squeeze the switch trigger until the blade shaft moves slowly and
stop the motor when the blade shaft is at or near the bottom of its stroke, Fig.
6.
DISCONNECT TOOL FROM POWER SOURCE.
Fig. 1
Fig. 2
Fig. 3
A
B
ASSEMBLY TOOLS REQUIRED - None
ASSEMBLY TIME ESTIMATE - 15-30 minutes