Filter
Top Products
17
Troubleshooting
Trouble Probable Cause Remedy
Finished stock is
concave on the end.
Knife tip is higher than outfeed table.
Raise outfeed table until it is on the
same level with tip of knife. See page
11.
Back end of stock is
thicker than front side.
Knife tip is not leveled with outfeed
table.
Adjust outfeed table to align with knife
tip. See page 11.
Finished stock is
concave in the middle.
Both tables have to much end fall.
Raise tale ends by adjusting the screws
at the four corners under the tables.
See Figure 28 below.
Two tables are not in
line.
Adjust using the screws shown in
Figure 29. (Remove protective caps to
access screw).
Ends of finished stock
are cut more than the
middle.
Table ends are raised higher than the
middle.
Lower both table ends with the
adjustment screws. See Figure 28.
Figure 28 Figure 29
Replacement Parts
Replacement parts are listed on the following pages. To order parts or reach our service department, call 1-
800-274-6848, Monday through Friday (see our website for business hours, www.powermatic.com). Having the
Model Number and Serial Number of your machine available when you call will allow us to serve you quickly
and accurately.