Filter
Top Products
Basic Operation Instructions 13
www.silverstarmobility.com Removable Battery Pack
Mobility Product Battery Charging
The battery pack’s internal charger
is capable of charging the batteries
of the mobility product you are
transporting. This option is only
available for Backpacker Series and
SilverBoom lifts. The internal
battery pack is also capable of
charging a 24-volt mobility product
equipped with a compatible Neutrik
NC3MXX connector (for pin
configurations, see figure 7).
To charge the mobility product’s
batteries:
1. Ensure the battery pack is
plugged into the vehicle’s auxil-
iary outlet.
2. Plug the charger cord into the
off-board charger port on the
mobility product. See figure 6.
BATTERY CHARGER LEDs
The LEDs on the side of the battery
pack (see figure 8) indicate charging
status. (See the table below.) Each
battery has its own LED. The right
LED indicates the charging status of
the 12-volt lift battery. The left LED
indicates the charging status of the
24-volt mobility device.
12-VOLT LED
24-VOLT LED
Figure 6. Charging A Mobility Device
PLUG INTO
AUXILIARY
OUTLET
LED CONDITION
Fast flashing LED Indicates charge verification (do batteries need charging?)
Slow flashin
g
LED Indicates the batter
y
is char
g
in
g
LED is soli
d
Indicates the batter
y
is char
g
ed above 95%
Both LEDs are off Indicates the charger is off
Alternately flashing LEDs Indicates a fault
Both LEDs alternatel
y
flash 3 times Indicates the batteries are not connecte
d
Figure 8. Battery Pack LEDs
Figure 7. Pin Configuration
PIN 1 = BATTERY +
PIN 3 = BATTERY -
PIN 2 / PIN 3 JUMPERED =
INHIBIT HIGH